Hardend Stell Nozzel with DLC coating compatible with v6 and the Dragon/Drangonfly Hotends. Temperature resistant up to 450›C.
Ideal for abrasive filaments with Carbon Fiber, Steel, Wood, Boron Carbide, Tungsten and Phosphorescent particles.
DLC coating on whole nozzle surface with its hardness HV2500, thickness 2‘m, and friction coefficient 0.03, the result is a fine finish with high wear resistance and low friction.
Min. orifice diameter 0.2mm/¤0.01mm in experimental level application, making sure high accuracy printing.
Special processing technology and post-treatment make the nozzle without burr at the edge of tip and without debris in the hole; Lasting gloss for a long time without oxidation.
Inner hole roughness lower than Ra0.4; Higher smoothness and less adhesion.
First-class quality brass material ensures the stability of properties.
Wide application with high performance, printing well with conventional material, such as PLA, ABS, TPU, PA, PP, PC, ASA, Nylon, PETG, PVA, HIPS and etc.
Available sizes: 0,25mm, 0,4mm, 0,6mm.
Applicable for 1,75mm filaments.